Palmer Safety
Palmer Safety C-Slab Grabber Guardrail Stanchion
This product usually ships out in just 1 - 2 days.
Earn rewards points.
Product Description
Palmer Safety C-Slab Grabber Guardrail System
The Palmer Safety C-Slab Grabber is a heavy-duty guardrail system designed for fall prevention applications on concrete slabs. Built from powder-coated and galvanized steel, this system provides a durable, corrosion-resistant solution for protecting workers at height. It’s an ideal option for creating temporary guardrails on leading edges, decks, and similar job sites where traditional fall protection methods are not feasible.
Features & Benefits
- Durable powder-coated steel construction resists corrosion and job site damage.
- Adjustable design fits concrete beams from 1-1/2" to 36" thick.
- Quick-adjust handle makes repositioning easy as work progresses.
- Compatible with cable, snap-on metal rails, and overlapping 2x4s or 2x6s.
- Backup safety system with anti-slip tape for added security.
- Lightweight and portable at only 22 lbs.
- Easy compliance—meets or exceeds OSHA 1910 and OSHA 1926 Subpart M standards.
Specifications
- Material: Powder-coated and galvanized steel
- Weight: 22 lbs
- Adjustment Range: Fits concrete beams 1-1/2" to 36" thick
- Maximum Spacing Between Units: 8 feet
Installation Requirements
- Toprails must be installed 42" (+/- 3") above the work surface, or 42" plus the height of stilts if applicable.
- Toeboards are required on surfaces with a slope greater than 4/12 (vertical/horizontal).
- Toeboards must measure at least 3½" from the top edge to the work surface, with no more than 1/4" gap at the bottom.
- Follow all equipment instructions for proper installation and safety compliance.
Important Safety Information
The C-Slab Grabber Guardrail System is a fall prevention system only. It is not a fall protection or fall arrest system. It must never be used for fall arrest, work positioning, climbing, rescue, or any application where a personal tie-off is required. This system is designed to prevent workers from reaching the edge in the first place, not to stop a fall in progress. Always install according to the manufacturer's instructions and comply with OSHA 1910 and 1926 Subpart M regulations.
Specifications
Safety Notice
Although Bishop Lifting strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Bishop Lifting disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.
Bishop Lifting rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Bishop Lifting disclaims liability for any misuse or incorrect product selection by our customers.
Rigging and safety gear purchased from Bishop Lifting should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.
Q&A
Related Products
Palmer Safety
Palmer Safety Parapet Clamp Guardrail Stanchion
Palmer Safety
Palmer Safety Guardrail Warning Line Stanchion
Palmer Safety
Palmer Safety Full Body Safety Harness Kit
Palmer Safety
Palmer Safety Tripod SRLD Bracket
Palmer Safety