Product Description
Modulift Modular Spreader Beams provide the ideal solution for most lifting requirements, combining versatility and cost-effectiveness! The Modulift system truly allows you to build, re-build and reconfigure spreader beams to match the span and capacity you need. A typical setup consists of any number of struts, the end units, the drop links and finally, shackles. We can supply shackles for you, or, if you already have the proper shackles you can simply use them, saving even more money.
- This is a 1ft long strut for the MOD 50 beam size
- The MOD 50 beam size is rated @ 50 Tons Safe Working Load (SWL) @ 21ft span
- Different span lengths or steeper Base to Sling Angle (BSA) measurements may impact the SWL for you system--review the PDF file on the Attachments tab for more information
- Mix and match this strut with other MOD 50 struts to achieve the span (length) that you require
- Be sure to order two MOD 50 end units and MOD 50 drop links as well (this is for a typical beam setup)
- Lastly, make sure you have proper shackles available, or plan to purchase those from us as well
- The MOD 50 beam size calls for 35t shackles on top (larger) and 25t shackles on bottom (smaller)
- Be sure to use bolt, nut and cotter shackles, such as Crosby G-2130 or Green Pin G-4163
- Slings can also be had, and we offer many types online, but can also custom build a sling to match your exact needs
Need help deciding which MOD system to go with? Refer to the charts below to view available strut sizes, as well as span (length) and corresponding load capacities.
Specifications
Safety Notice
Although Bishop Lifting strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Bishop Lifting disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.
Bishop Lifting rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Bishop Lifting disclaims liability for any misuse or incorrect product selection by our customers.
Rigging and safety gear purchased from Bishop Lifting should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.