Duckbill
Duckbill 68-DTS 1/8" Tree Anchor Kit - 1100 lbs Capacity
Product Description
Ideal for trees and bushes in landscape, orchard and nursery applications, each Duckbill kit comes pre-assembled and will anchor one tree.
Safe: No rigid rods remain above ground to injure people or pets or damage lawn care equipment.
Strong: The earth anchor rotates into undisturbed soil for a secure hold.
Easy: Installation includes three simple steps--drive anchor to desired depth, remove drive steel and pull up on cable, and place tree collar around tree above limb to secure.
For trees up to 6" diameter.
Specifications
What's Included
View table below for details on kit contents.
Safety Notice
Although Bishop Lifting strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Bishop Lifting disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.
Bishop Lifting rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Bishop Lifting disclaims liability for any misuse or incorrect product selection by our customers.
Rigging and safety gear purchased from Bishop Lifting should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.
Product Reviews
- Highest to Lowest
- Newest to Oldest
- Favorite Reviews
- All Ratings
- 5 ★ Reviews
- 4 ★ Reviews
- 3 ★ Reviews
- 2 ★ Reviews
- 1 ★ Reviews


I had two quotes for a guying system to straighten 3 trees hit by a contractor on a Bobcat. This included labor but the quotes was 1200 and the other one was $1,400. I bought this system from duck bill for less than $200 I did it myself. They were out of stock at the driving pin but the salesman told me to just use half inch rebar which is significantly cheaper. I used the grinder to shape the tip of the rebar so it wouldn't get stuck in the anchor . That worked out great.