Westechrigging.com is now Lifting.com Learn More
Westechrigging.com is now Lifting.com Learn More
Image shown may be a stock photo and is for reference only.
The Petzl P15 GO Quick Link is a type of connector commonly used in climbing and rigging applications. It is designed to create a temporary or semi-permanent connection between components.
To safely use this connector, follow these general steps:
Assess the application: Determine the specific use case and ensure that the P15 GO is suitable for the intended purpose and load requirements. The Petzl P15 GO Quick Link is designed for use in a wide range of activities, including climbing, caving, and industrial applications.
Prepare the components: Ensure that the components to be connected are clean, free of any damage, and compatible with the Quick Link. The P15 GO has a specified diameter and breaking strength (25 kN), so make sure that the components being connected are within the specified limits.
Open the link: Rotate the nut or screw to open the gate. This will create an opening for insertion of the components.
Insert the components: Place the components to be connected into the opening of the quick link.
Close and secure the quick link: Once the components are inserted, rotate the nut or screw in the opposite direction to close the gate of the quick link. Ensure that the gate is fully closed and tightened to provide a secure connection. Use of a wrench to apply moderate torque is acceptable, but do not overtighten and damage the threads.
Check the connection: Inspect the quick link and the connected components to ensure that everything is properly aligned and secure. Verify that the gate is fully closed and that there are no visible signs of wear, damage, or misalignment.
To avoid serious injury or loss of life, the Petzl P15 GO Quick Link should only be used in accordance with the manufacturer's instructions and guidelines, and applicable industry standards.
Additionally, regular inspections should be performed to check for wear, damage, or deformation. If any issues are detected, the P15 GO should be replaced to maintain safety and reliability.
Remember, proper training and knowledge of best practices for climbing and rigging are essential no matter what type or brand of equipment you are using.
Although Bishop Lifting strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Bishop Lifting disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.
Bishop Lifting rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Bishop Lifting disclaims liability for any misuse or incorrect product selection by our customers.
Rigging and safety gear purchased from Bishop Lifting should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.
